Bloody Belladonna tut...

Supplies Used:

My Bloody Valentine tube by Zindy. Get it HERE.

Scrap kit called Belladonna by Addictive Pleasures. Get it from her store HERE. (Sorry the store is down as I am writing this or I would direct link for ya)

Eyecandy 4000 Glass & Gradient Glow (Font Only)

Font: Bleeding Cowboys

Open a new image size 500 by 500.

C/P Frame 2. Resize by 75%.

Select the inside of the frame with your magic wand. Go to selections, Modify, Expand by 5.

Add a new raster layer. C/P Paper 2 into selection. Deselect and move paper under the frame.

C/P Web. Resize by 50%. Go to Adjust, Color Balance, Negative Image. Dropshadow.

C/P Light shade. Resize by 30%. Dropshadow. Position just under the edge of the frame. Duplicate. Change the layer opacity to multiply.

Dropshadow Frame.

C/P Thorns 2. Resize by 50%. Dropshadow. Position just left of the frame.

C/P your tube. Dropshadow. Position on the right of the frame.

C/P Ivy. Resize by 50%. Dropshadow. Position just under one side the frame. Duplicate and mirror.

Duplicate Ivy. Image rotate 90 degrees. Duplicate again. Flip and mirror. Position both on the left side of the frame.

C/P Thorns. Image, Rotate 90 degrees. Resize by 50%. Dropshadow. Position about halfway up the tube.

C/P Roses. Image, Rotate, Free Rotate 90 Degrees. Dropshadow. Duplicate and mirror. Position both over the bottom of your tube so they meet in the middle.

C/P Rose. Resize by 30%. Position near the center of the black roses.Dropshadow. Duplicate and position next to the original. Merge down. Duplicate and change the layer property to multiply.

C/P Rose 3.  Resize by 30%. Dropshadow. Position under one side of the red roses. Duplicate and mirror. position under the other side of the roses.

C/P Leaves. Resize by 30%. Dropshadow. Duplicate and mirror. Position under the single black roses.

If using the same tube as me C/P the heart alone. Resize by 50%. Dropshadow. Duplicate and mirror. Position both hearts Between the red and black single roses. (No worries if you use another tube there is a heart in the kit.)

C/P Light 2. Resize by 30%. Dropshadow. Duplicate. Position just under the edge of the top of the roses.

C/P Netting 3. Mirror. position under the left bottom of the frame. Dropshadow.

C/P Glass. Resize by 30%. Dropshadow. Duplicate 3 times. Position these about halfway up the frame and across half the bottom.

C/P Decor. Resize by 50%. Dropshadow. Position near the bottom left corner of the frame.

C/P Candle. Resize by 40%. Use your deform tool to rotate slightly. Dropshadow. Move this under the cage.

C/P Goblet. Resize by 40%. Dropshadow. Duplicate and position one slightly higher than the other. Move under the candle.

C/P Cross. Resize by 40%. Use your deform tool to angle slightly. Dropshadow. Move below the goblets.

C/P Candle. Resize by 40%. Dropshadow. Move under the cross.

C/P Box. Mirror. Resize by 30%. Dropshadow. Position just over the roses.

C/P Mask. Resize by 40%. Go to Adjust, Color Balance, Manual color correct. Source set to black, Target to red. Dropshadow. Use your deform tool to position over the box and birdcage. Adjust, Sharpness, Sharpen. Duplicate and change the layer property to multiply.

Type out your font at the top of the frame. Apply Eyecandy 4000 Glass. Apply Gradient Glow of 3. Dropshadow.

Don't forget your copyright and watermark.