SteamPunker...

Supplies Used:

SteamPunker tube By Screaming Demons. Get it at SATC.

Kit called Steampunkers by Inzpired Creationz. This kit was made to compliment this tube!! You can also get this at SATC.

Eye candy 4000 Chrome & Gradient Glow

Font: SinGothic

Open a new image size 500 by 500

C/P Frame 3. Resize by 65%.

Use your lasso tool to select all the way around the frame. Add a new Raster layer. C/P paper 3 into selection. Deselect and move below the frame layer.

C/P your tube. Use your eraser to remove any bits that stick out over the frame. 

C/P Hat Pin. Resize by 40%. Use your deform tool to position about halfway up the right side of the frame. 

C/P Umbrella 1. Mirror. Resize by 50%. Position over the stick portion of the hatpin.

C/P Luggage. Resize by 40%. Position at the bottom of the umbrella handle. Duplicate 2 times. Change the layer property on the duplicates to multiply.

C/P Shoes. Resize by 30%. Position to the right of the luggage.

C/P Hat. Resize by 30%. Position to sit on top of the luggage. Duplicate and change layer property to multiply.

C/P phone. Resize by 30%. Position to the left of the luggage.

C/P Clock. Resize by 40%. Move under the phone layer.

C/P Hatpin. Resize by 75%. Use your deform tool to position under the clock.

C/P Chain. Resize by 65%. Position over the top left of the frame.

C/P Butterfly 3. Resize by 10%. Position to sit on the umbrella.

Type out your font and duplicate. On the original add Eye Candy 4000 Chrome.

Then a Gradient glow of 3.

On the top layer change the layer property to overlay.

Dont forget your copyright and watermark :)